Technical data

Product Fault Management, Continued
MEMCON 00010101
MEMORY CONFIGURATION:
MS44-AA Simm Memory Module (4MB)
Loc 0A
MS44-AA Simm Memory Module (4MB)
Loc 0B
MS44-AA Simm Memory Module (4MB)
Loc 0C
MS44-AA Simm Memory Module (4MB)
Loc 0D
_Total memory = 16MB
_sets enabled = 00000001
MEMORY ERROR STATUS:
SIMM MEMORY MODULES: LOCATIONS 0A
& 0B
Set = 0(X)
Bank = B
MEMCON3 8B000003
64 bit mode
Base address valid
RAM size = 1MB
base address = 0B(X)
$ SHOW MEMORY
System Memory Resources on 21-FEB-1992 05:58:52.58
Physical Memory Usage (pages): Total Free In Use Modified
Main Memory (128.00Mb) 262144 224527 28759 8858
Bad Pages Total Dynamic I/O Errors Static
1 1 0 0
Slot Usage (slots): Total Free Resident Swapped
Process Entry Slots 360 347 13 0
Balance Set Slots 324 313 11 0
Fixed-Size Pool Areas
(packets): Total Free In Use Size
Small Packet (SRP) List 3067 2724 343 128
I/O Request Packet (IRP) List 2263 2070 193 176
Large Packet (LRP) List 87 61 26 1856
Dynamic Memory Usage (bytes): Total Free In Use Largest
Nonpaged Dynamic Memory 1037824 503920 533904 473184
Paged Dynamic Memory 1468416 561584 906832 560624
Paging File Usage (pages): Free Reservable Total
DISK$VMS054-0:[SYS0.SYSEXE]PAGEFILE.SYS 300000 266070 300000
Of the physical pages in use, 24120 pages are permanently allocated
to VMS.
$
Using the VMS command ANALYZE/SYSTEM, you can associate
a page that had been replaced (bad pages in SHOW MEMORY
display) with the physical address in memory.
Continued on next page
5–75