Technical data

System Power-Up Test, Continued
At the end of the power-up sequence the system enters
console mode, as indicated by the >>> prompt, if the HALT
parameter is set to 3. If the HALT parameter is set to 1 or 2,
the system tries to boot the default boot device.
During initialization, the system is configured by creating the
main configuration table (MCT) and the device configuration
table (DCT).
Figure 5–1 Successful Power-Up
KA49-A V1.0
32MB
08-00-2b-04-03-12
LJ-01824-TI0
>>>
OK
Continued on next page
5–5