User`s guide

Chapter 6. Troubleshooting
EK–KZPBA–UG. B01 6–5
Table 6–3 Boot Sequence Troubleshooting Table
Symptom Probable Cause Corrective Action
Boot failure Incorrect boot device
was specified at the
console boot command.
Re-define the default boot device. Refer to
y
our s
y
stem user's
g
uide for specific
environmental parameter settings.
KZPBA-CA is not termi-
nated properly.
Ensure each end of the SCSI bus is termi-
nated.
KZPBA-CA is in an un-
known state.
Initialize the adapter b
y
either enterin
g
the
SRM console
init
command or press
the system reset button.
Device not
reco
g
nized
during boot.
KZPBA-CA is not termi-
nated properly.
Ensure each end of the SCSI bus is termi-
nated.
Operatin
g
s
y
stem not
configured correctly.
Reconfi
g
ure s
y
stem software. Refer to
system documentation.
Operatin
g
s
y
stem does
not contain device driver
or driver not installed
correctly.
If runnin
g
"Windows NT", ensure the de-
vice driver is installed. If runnin
g
DIGITAL
UNIX or DIGITAL OpenVMS, ensure that
the OS revision level supports the KZPBA-
CA.