User`s guide

Chapter 5. QLogic Fast!Util
EK–KZPBA–UG. B01 5–7
3. Use the
Tab
key to select an entire group of settings or the arrow key to
select the setting for one SCSI ID at a time. Press the
Enter
key to toggle
the setting option. Table 5
−
3 shows the default SCSI device settings.
4. Press the
Esc
key to return to the
Configuration Settings
menu when you
complete the SCSI device settings.
Table 5−3 SCSI Device Settings
Settin
g
Ran
g
e Default
Enable Devices Yes or No Yes
Disconnects OK Yes or No Yes
Check Parit
y
Yes or No Yes
Ne
g
otiate Wide Yes or No Yes
Ne
g
otiate S
y
nchronous Yes or No Yes
Ta
gg
ed Queuin
g
Yes or No Yes
Enable LUNs Yes or No Yes
S
y
nc Offset
S
y
nc Period
5.3.3 Auto–configuring SCSI Devices
Use
Auto–configure SCSI Device
to optimize SCSI device settings. The auto–
configure option causes the KZPBA-CA to scan the devices on the SCSI bus and
set options for the devices based on each device’s capabilities. To auto–configure
SCSI devices, follow these steps:
1. Use the arrow keys to move the cursor to
Configuration Settings
on the
Fast!Util
main menu and press the
Enter
key. The
Configuration Settings
menu appears as shown in Figure 5
−
2.
2. Use the arrow keys to move the cursor to the
Autoconfigure SCSI Devices
option on the
Configuration Settings
menu and press the
Enter
key. The
utility displays the message:
Checking SCSI ID #
.