User`s guide

Chapter 4. EEROM Configuration Utility
EK–KZPBA–UG. B01 4–7
Figure 4–5 The Edit EEROM Host Adapter Parameters Screen
+================Edit EEROM Host Adapter Parameters============= +
| |
| Parameters Default New |
|FIFO Threshold 3 [ 0 ] |
|Host Adapter Enable 1 [ 1 ] |
|Initiator SCSI ID 7 [ 7 ] |
|Bus Reset Delay 1 [ 1 ] |
|Retry Count 0 [ 1 ] |
|Retry Delay 1 [ 1 ] |
|Asynchronous Data Setup Time 9 [ 9 ] |
|REQ/ACK Active Negation 1 [ 1 ] |
|Data Line Active Negation 1 [ 1 ] |
|Data DMA Burst Enable 1 [ 1 ] |
|Command DMA Burst Enable 1 [ 1 ] |
|Tag Aging 8 [ 8 ] |
|Low Termination Enable 1 [ 1 ] |
|High Termination Enable 1 [ 1 ] |
|Selection Timeout 250 [ 250 ] |
|Maximum Queue Depth 256 [ 256 ] |
|FIFO 128 Threshold Enable 0 [ 0 ] |
|Fast RAM Enable 1 [ 1 ] |
|SCSI Reset Disable 0 [ 0 ] |
|Enable Auto Termination 1 [ 1 ] |
| |
| <(O)K> <(C)ancel> |
+=============================================================== +
2. Press
Enter
or use the up and down arrow keys to move through the list of
parameters. To change a parameter value, backspace over the value in the
New
field and type in a new value. If you enter a value out of the range for
this parameter, the utility will display an error message indicating the valid
range. Table 4
−
1 lists the default FIFO thresholds for various chips.