User`s guide

KZPBA–CA PCI-to-UltraSCSI Host Adaptaer
3–18 EK–KZPBA–UG. B01
3.7.2 For Systems Running Alpha BIOS
If your system is running with an Alpha BIOS, verify the proper installation of
the KZPBA-CA as follows:
1. Power up your system; after the Alpha AXP goes through its start-up
sequence the Alpha BIOS initialization screen should appear.
2. Press
F2
for setup.
3. Select
Display System Configuration…
from the
Alpha BIOS
setup menu.
4. Select
Hard Disk Configuration
from the
Display System Configuration
menu and then press
Enter
. The system will now display the devices that
are attached to the Qlogic adapter.
5. Press
ESC
to exit the
Hard Disk Configuration
menu.
6. Select
PCI Configuration
to display the configuration of the Qlogic adapter.
7. Select
SCSI Device
to list the installed Qlogic adapter.
8. Press the
ESC
key repeatedly until you have returned to the Windows NT
operating system boot menu.
3.7.3 Verifying Installation on Intel-Based Systems
If you are using the Windows NT operating system on an Intel-based system,
verify the proper installation of the KZPBA–CA as follows:
1. Turn on the power to your system.
2. Verify proper installation of the KZPBA–CA during system boot. Look for a
BIOS initialization process message similar to the following:
QLogic Corporation
PCI SCSI ROM BIOS Version X.XX
Copyright © Qlogic Corporation 1993-97 All Rights Reserved
Press <Alt-Q> for Fast! Util
ISP Firmware X.XX
Using IRQ number X
Device Device Adapter SCSI SCSI Vendor Product Product
Number Type Number ID LUN ID ID Revision
81 Disk 0 0 0 XXX XXX XXXX
If no SCSI disk devices are attached to the computer, an error or status
message appears.