User`s guide

Chapter 3. Installing the KZPBA–CA Adapter
EK–KZPBA–UG. B01 3–3
Figure 3–1 KZPBA–CA Single-Ended Host Adapter
CAUTION
To protect the board from static discharge, wear
an electrostatic discharge (ESD) wrist strap. If a
wrist strap is unavailable, ground yourself by
touching a bare metal surface on the computer
chassis before you open the case.
1. Turn off the power to the computer system and attached peripherals.
Disconnect the power cords.
2. Remove the computer cover.
3. Locate an available PCI bus slot. PCI slots are shorter than ISA and EISA
slots and are normally colored white. (Refer to your system hardware
manual to determine the location of the PCI bus slot in your system.)
Unscrew and remove the outside slot cover. The slot cover is the metal strip
that covers the opening in the rear of the computer chassis and where the
external connector on the adapter fits (save the screw.)
4. Carefully remove the KZPBA–CA PCI-to-UltraSCSI host adapter from its
protective anti-static bag and insert it into the slot. Press down on the top of
the card until it seats firmly. See Figure 3–2.