User`s guide

KZPBA–CA PCI-to-UltraSCSI Host Adaptaer
3–2 EK–KZPBA–UG. B01
3.2.1 User-Supplied Hardware and Software Requirements
The KZPBA–CA PCI-to-UltraSCSI Host Adapter requires the following user-
supplied hardware and software:
•
An AXP- or Intel-based computer system with a PCI local bus, a 3½-inch
(1.44 MB) floppy drive, an available PCI slot, disk space to load software
drivers, and the associated system hardware manual
•
The SCSI cables necessary to connect SCSI devices to the adapter module
•
One of the following operating systems (refer to the release notes for specific
supported operating system versions):
- Windows NT
- DIGITAL OpenVMS
- DIGITAL UNIX
3.2.2 KZPBA–CA Host Adapter Kit Contents
The KZPBA–CA Host Adapter kit contains the following:
•
KZPBA–CX PCI-to-UltraSCSI Host Adapter module
•
License Agreement
•
One diskette containing the AXP flash EEROM Configuration Utility and
operating system specific software drivers for both AXP and Intel Windows
NT based systems
•
This guide
•
Release Notes
Contact your Service Representative if any items are missing.
3.2.3 Back up Your System
Follow your normal procedures to back up your system before installing the
KZPBA–CA host adapter.
3.3 Installing the Host Adapter
Install the host adapter module using the following procedure. Take precautions
to protect the module from static discharge. The single-ended Host Adapter is
shown in Figure 3–1.