Installation guide

Adapter Setup
2-14
2. Highlight the Configure/View Host Adapter Settings option
and press the Enter key to select. The configuration menu is displayed.
3. The Host Adapter SCSI ID option appears highlighted. Press the
Enter key and a list of SCSI IDs is displayed.
4. Highlight 6 (for Host A) or 7 (for Host B) and press the Enter key.
5. Go to Deactivating On-Board Termination through the BIOS.
Deactivating On-Board Termination through the BIOS
To deactivate on-board termination with the SCSISelect Utility, follow these
steps:
1. Highlight the Host Adapter SCSI Termination option and press
the Enter key. A list of termination settings is displayed.
2. Highlight Low Off/High Off and press the Enter key.
3. Go to Disabling Power-On Reset.
Disabling Power-On Reset
To disable power-on reset, follow these steps:
1. Highlight Advanced Configuration Options from the SCSISelect
Utility Configuration menu and press the Enter key. The Advanced
configuration menu is displayed.
2. Highlight the Reset SCSI Bus at IC Initialization option.
Press the Enter key. A list of reset options is displayed.
3. Highlight Disabled and press the Enter key.
4. Press the Esc key to return to the Configuration menu.
5. Press the Esc key again and save the changes that you made when
prompted.
6. Press the Esc key to exit the SCSISelect Utility.
Go back to the following sections:
1. Setting Adaptec Host Adapter SCSI IDs and repeat same steps on Host B.