User`s guide

Chapter 3. Maintenance
EK–SMCPO–UG. A01 3–15
NOTE
To decrease the configuration number:
Press
the upper switch to step the address down one ad-
dress at a time (decrement) until the desired con-
figuration number is displayed.
To increase the configuration number:
Press the
lower switch to step the address up one address at
a time (increment) until the desired configuration
number is displayed.
9. Figure 3–9 shows the location of the switch. Figure 3–10 depicts the separate
step switches to set the subsystem to the desired SCSI bus configuration
(refer to the label at bottom of pedestal to cross reference slot SCSI ID ad-
dresses with switch settings).
Figure 3–8 Remove Screw and Panel