User`s guide

RAID Array 3000 Storage Subsystem
vi EK–SMCPO–UG. A01
Figures (continued)
3–8 Remove Screw and Panel.................................................................... 3–14
3–9 Location of SCSI Bus Configuration Switch ....................................... 3–15
3–10 Configuration Switch.......................................................................... 3–15
3–11 Remove Controller.............................................................................. 3–16
3–12 Release Locking Clips ........................................................................ 3–17
3–13 Remove Installed Memory Modules.................................................... 3–17
3–14 Install Replacement Modules.............................................................. 3–18
3–15 Pivot Module Down to Secure ............................................................ 3–19
4–1 Expansion Pedestal............................................................................... 4–1
4–2 Expansion Pedestal Slot Locations and ID Addresses............................ 4–3
4–3 Rear Panel Power Supplies ................................................................... 4–4
4–4 EMU Circuit Board Location................................................................4–5
4–5 Remove Side Cover from Base Pedestal ............................................... 4–7
4–6 Remove SCSI Bus Terminator..............................................................4–7
4–7 Disconnect SCSI Cable.........................................................................4–8
4–8 Connect SCSI Jumper...........................................................................4–8
4–9 Remove Connector Knockout Plate.......................................................4–9
4–10 Connect SCSI Cable ........................................................................... 4–10
4–11 Set Configuration Switch to 7............................................................. 4–10
4–12 Configuration Switch.......................................................................... 4–11
4–13 Reconfigured SCSI Bus Addresses...................................................... 4–11
4–14 Connect SCSI Cable Between Pedestals..............................................4–12
4–15 Power Cable Connections ................................................................... 4–13
4–16 Transfer Drives from Base to Expansion Pedestal............................... 4–14
5–1 Second Controlle Slot Position.............................................................. 5–2
5–2 Insert Module into SIMM Connector .................................................... 5–3
5–3 Pivot Module Down to Seat .................................................................. 5–4
5–4 Remove Controller from Top Slot.........................................................5–4