User`s guide

Chapter 3. Maintenance
EK–SMCPO–UG. A01 3–5
3.6 Replacing Components (FRU's)
This section describes how to replace an FRU in the RAID Array 3000 pedestal.
The information is divided into the following subsections:
•
Removing the pedestal door
•
Replacing an SBB
•
Replacing a power supply
•
Replacing the controller
•
Replacing the EMU board
•
Replacing the UPS
•
Replacing a controller memory cache module
3.6.1 Removing the Pedestal Door
Proceed as follows to remove the pedestal door (Figure 3–3):
1. Unlock and open the door to a 90º angle in relation to the pedestal.
2. Carefully lift up on the door until the hinge pins are against the top of
the mounting holes.
3. Pull the door straight out until the hinge pins clear the bezel.
Figure 3–3 Removing Pedestal Door