Installation guide

RAID Array 3000 Pedestal Enclosure
1–4 EK–SM3KC–IG. A01
8. Remove the existing controller (Figure 1-4) and install the third module into
the empty SIMM connector using the same procedure described in steps 6
and 7.
Figure 1–4 Remove Controller from Top Slot
9. Replace the existing controller into the top controller slot in the pedestal and
seat it into place by pushing forward on the side quick-disconnect handles.
Make sure the guides on each side of the controller align with the guides in
the slot.
10. Remove the dummy filler panel from the bottom controller slot by pulling
the handle straight out.
11. Install the second controller into the bottom controller slot and seat it into
place by pushing forward on the side quick-disconnect handles.
12. Power up the subsystem and refer to the
RAID Array 3000 Configuration
and Maintenance Guide
for information describing how to configure the re-
dundant controller option.