User`s guide

RA8000/ESA12000 HSG80 Solution Software V8.5 for Sun Solaris
Page 46 387372-005 AA–RFBPE–TE
To select another pair for Client, open the file containing the sockets in an ASCII
editor, after you have installed Client. Pick two numbers above 1023 that are not
already used in the file, and add the following two lines:
spgui number1/tcp # StorageWorks® Command
Console
spagent number2/tcp # StorageWorks® Command
Console
Note that the port numbers that you select must match the port numbers used by
all of the Clients to which you wish to connect your Agent.
Network Port Assignments for UNIX-Client/Server Systems
A UNIX host may use Network Information Services (NIS) to serve the services
file containing its network port assignments.
Agent must use the services file to determine which network ports to use.
Because of this requirement, you may need to configure your system so that
Agent can access the proper services file.
You have two options to prevent a conflict between the two possible locations of
the services file. See the Agent user guide for your particular Agent for more
information.
Error on First Attempt to Make Connection
You may experience a system error such as a “Command Execution Error” on
your first attempt to make a network connection using the Storage Window. If
this happens, try the connection again, and it will succeed.
Client Hangs when Virtual Disk Deleted
If Client is monitoring a particular subsystem, and you delete the virtual disk
being used to communicate with that subsystem, the program may hang. To
delete the virtual disk Client is using for communications with an Agent, you
must first reassign another virtual disk as the communications LUN, using the
Agent configurator.
If you are using the Command Console LUN (CCL) as your communications
LUN, and you disable it, Client may lose its connection with your subsystem. If
you wish to disable the communication LUN, you must first reassign another
virtual disk as the communications LUN.