User`s guide

Release Notes
AA–RFBPE–TE 387372-005 Page 43
Mirrored Cache Mode Not Retained After Configuration Restore
If you restore your controller configuration from a configuration file, the
mirrored cache setting may not be properly enabled. You must restore the
mirrored cache setting manually, using a CLI Window.
Error Message on Exiting Storage Window
Under certain conditions, when you exit a Storage Window, you may experience
an “Illegal Operation Error” message. You may ignore this message.
Inappropriate Error Message on Device Delete
If you select a disk, then chose Device/Delete, a dialog box may appear, asking
“Are you sure?”. If you choose the “NO” option, the message “Nothing selected
to delete!” is displayed. You may ignore this message.
Storage Window Corruption After Making/Removing Spare Device
If you select a disk and make it a spare (using either menu or context menu
options), then remove the device as a spare, some information in the Storage
Window may be left corrupted. To reconstruct the window, you must exit the
window and open a new one.
Cache Policy Not Shown in Controller Properties Sheet
The controller cache policy may not be properly shown in the controller
properties sheet. The field may be blank. You must use a CLI Window to obtain
the cache policy setting.
Incorrect Capacity Shown in Add Virtual Disk Wizard
In some circumstances, in Step 3 of the Add Virtual Disk Wizard, if you specify
a capacity greater than the available disk capacity, an error message results. If
you back up to Step 2 of the Wizard and return to Step 3, the correct capacity is
then displayed. An attempt to move to Step 4 of the Wizard at this point,
however, results in the same error message, even though the correct capacity is
shown.
To complete your virtual disk, you must exit the Wizard and attempt to recreate
the virtual disk.