User`s guide

Release Notes
AA–RFBPE–TE 387372-005 Page 41
Delayed Event Notification on RAS Connections
Visual fault notification, paging, and NT Event Logging may be delayed
significantly in situations where RAS connections are used for multiple Clients.
An Agent with multiple Clients in its client.ini file must poll each Client
whenever a fault occurs. Any Clients not currently network-connected
significantly delay this process, because Agent must wait for their connections to
time out before moving on to the other Clients.
To avoid this situation, set the notification_method parameter for each Client in
the client.ini file to “0”, to defeat event fault notification.
CLI RUN Commands
Do not issue RUN commands in the CLI Window. Use only a maintenance
terminal connection to issue RUN commands.
Creating Partition Units Across Targets or Ports
Be aware that the name you pick for a unit assigns it to a particular host bus
target. If you create a unit from free space on a device, the program forces you
use a unit name that puts the unit on the same host target as the other partitions
on the device.
On dual-port controllers, partitions on the same device that are assigned to
different host ports are not supported.
No Code Load in Multiple-Bus Failover Mode
The controller code load feature is not functional in multiple bus failover mode
for non-OpenVMS network connections. Do not attempt to update your
controller’s software in this mode.
Maximum Members Dependent upon Virtual Disk Type
The maximum number of members allowed in a RAID-based virtual disk is
dependent on the disk type. However, concatenated sets are now available for
JBOD’s, stripes and Raid 3/5 sets.