User`s guide

Release Notes
AA–RFBPE–TE 387372-005 Page 39
Failover Mode Set in CLI
Client is intended to be used to configure and monitor your storage only, and
there are some functions available in the CLI that are not available in graphic
form in the GUI. If you wish to use your controller’s multiple-bus failover mode,
you must enable and control that function via the CLI.
Also, if you wish to use virtual disk preferencing in multiple-bus failover mode,
you must set your virtual disk preferences via the CLI when you set the failover
mode.
No Direct Host Bus Connections on Windows 95 and Windows 98
Direct host bus connections are not supported on Windows 95 and Windows 98.
Only serial and network connections are supported.
Connection Limitations
Local SCSI or serial connections are only available with standalone Storage
Windows. You cannot use the Storage Window Manager to connect locally to a
subsystem.
Some Features Dependent upon Connection Type
Because of the nature of the connections you can use between Client and your
subsystems, the features available with each connection type vary slightly. Some
connection types impose limitations on Client’s features, as noted in Table 5.