User`s guide

Release Notes

AA–RFBPE–TE 387372-005 Page 37

10. To set the communications port and baud rate for the pager modem, select

Options/Preferences to view the Event Notification Preferences menu. You

can also set the subsystem polling interval on this menu.

11. You can establish paging on three separate levels: You can establish paging

on all levels on any combination of levels.

a) My Enterprise – Notifies all notifications list listed here for problems on all

systems and subsystems

Highlight “My Enterprise” in the Storage Window Manager and then select

/File/Properties/Event Notification from the menu. Clicking on the

Notification List box will list all of the lists you have created. Choice the list

for persons that should be notified in case of a failure on any system.

System Level – Notifies all notifications lists listed here for problems on the

specific system and all its subsystems selected

12. Highlight the desired system name in the Storage Window Manager and then

select /File/Properties/Event Notification from the menu. Clicking on the

Notification List box will list all of the lists you have created. Choice the list

for persons that should be notified in case of a failure on any subsystem of

this specific system.

13. Subsystem Level - Notifies all notifications lists listed here for problems on

the specific subsystem selected

14. Highlight the desired subsystem name in the Storage Window Manager and

then select /File/Properties/Event Notification from the menu. Clicking on

the Notification List box will list all of the lists you have created. Choice the

list for persons that should be notified in case of a failure on this specific

subsystem.

15. You have completed the paging notification setup. You may find that you

will have to make modifications in order to work with various paging

systems throughout the world.

Operating Parameters of Partition Virtual disks

Keep in mind that virtual disks based on partitions on any container are all

closely related. They all share the same target and operating parameters of the

container. If you change any of this information for one partition on the

container, it automatically changes for all the partitions on that container.