User`s guide

RA8000/ESA12000 HSG80 Solution Software V8.5 for Sun Solaris
Page 36 387372-005 AA–RFBPE–TE
Setting Up Pager Notification
You may need to tune the pager notification feature for proper functioning with
certain pager systems. The pager feature supports both alphanumeric and
numeric pagers and allows for notification of multiple pagers. You can select
multiple pagers to be notified for multiple storage subsystems within different
blocks of time. You can also temporarily disable any pager.
Use the following procedure to set up and tune the pager notification system:
1. In Storage Window Manager, select Options/Event Notification/User Profile.
2. Click on New and enter the name of the person to be notified.
3. Select the Pager folder and enter the person’s pager number, along with any
prefixes required to reach the outside phone system. It is good practice to
place delays as commas (,) after any exchange switch that might occur. Each
comma results in two seconds of delay. An example is: 8,,1, 800,5551212.
In this example, there is a 4-second delay between the 8 and the 1.
4. Select the Alphanumeric box if the paging system supports it. Leaving the
box blank results in numeric paging only.
5. Click on the Enabled box to enable paging to this person.
6. Enter the start and end times that this person is available for paging. If you
want 24 hour coverage, enter a start time of 0:00 and an end time of 24:00.
You must enter a time period for paging. Leaving the start and end times at
0:00 has the effect of canceling paging for this person.
7. Close the User Profile menu.
8. Select Options/ Event Notification/Notification List, to list all of the persons
to be notified as a named group. (Later, you will be able to assign these
groups to individual systems.) You can enter a description along with the
name to state such information as times and subsystems that this person
supports.
9. If you’re using numeric paging, you can view the failure codes that are used
under Options/Event Notification/Pager codes.