Installation guide

25
Controller Slot Locations
$
DIGITAL Server Systems
NOTE:
DIGITAL Server systems that have PCI on board
video controllers in the server are not compatible with the
remote console feature of the RSM. An external ISA VGA
video controller is required to support the remote console
feature.
For DIGITAL Prioris XL Server, use slots 2 through 5.
For DIGITAL Prioris HX 590/590DP, use one of the lower EISA slots and
remember to remove jumper
J42
.
For DIGITAL Prioris HX 5100MP, use one of the lower EISA slots and
remember to remove jumper
J42
.
For DIGITAL Prioris HX 6000, use one of the lower EISA slots. Set switch 1,
position 5 to OFF.
For DIGITAL Prioris ZX 5000MP, use one of the lower EISA slots. Remove
Jumper J19 located directly above the RSM control cable on the main logic board
daughter card, between the fan and front bezel assemblies.
For DIGITAL Prioris ZX 6000MP, use one of the lower EISA slots and turn
switch 5 on the J35 MLB switch block to OFF (down).
For DIGITAL Server 7100 series, use one of the lower EISA slots. Remove
Jumper J19 located directly above the RSM control cable on the main logic board
daughter card, between the fan and front bezel assemblies.
For DIGITAL Server 5100/5200 series, use one of the lower EISA slots and turn
switch 5 on the J35 MLB switch block to OFF (down).