Installation guide

Troubleshooting the Controller

Locate connector J10 on the controller. Move the jumper from pins 5 and 6

and place it over pins 9 and 10 as shown below.

Reconnect the power cable to power on the controller. On XL servers,

replace any panels or covers that you removed earlier and power on.

Before the OS is loaded, power back down.

Observe the LED on the controller. The LED should be a steady

green

Disconnect the power cable from the controller. (On XL servers, remove the

panels or covers as in step 1 above.)

Remove the jumper from pins 9 and 10. Place it back over pins 5 and 6.

Reconnect the power cable, replace any panels or covers that you removed

earlier, and return the server to normal service, being sure to follow the

power-on sequence shown in step 7 of Chapter 2.

Select no user or password in the preference Window. Refer to the

Remote

Server Management Station Software User’s Guide

to set the password

You must also restore all the customized data in the flash file by downloading the

event, script, macro, and security files from the management station.