Installation guide

Remote Server Manager Hardware Installation Guide
8
Step 1. Install the Controller in the Remote Server
CAUTION: Be sure that the server is not in use before you
proceed.
Static electricity can destroy the circuits in the system or
controller. Discharge static electricity by touching the metal
chassis of the system before touching any part of the system
backplane, motherboard, or the controller. It is recommended
that you use an anti-static strap.
Refer to your server user’s guide to:
1. Power down the server.
2. Remove the power cord.
3. Remove any covers necessary to gain access to the EISA expansion slots.
4. Install the controller in an EISA bus master slot. It is recommended that
you use the lowest EISA slot to ease installation of the reset cable, as the
controller may block the MLB connector when installed in other slots.
Refer to the server user’s guide to identify the EISA bus master slots.