Installation guide

7
Controller Installation

This chapter describes how to install the controller into the remote server.
You should refer to your server documentation for the proper procedures to power
down and to remove any covers to gain access to the EISA bus master expansion
slots
.
Installation Overview
The RSM controller installation procedure consists of the following steps.
Complete each step before continuing on to the next step.
1. Installing the controller in the server
2. Connecting the reset cable to the server
3. Connecting an external power supply
4. Connecting the keyboard to the controller
5. Connecting the modem to the controller
6. Connecting to an optional UPS
7. Powering up
8. Running the SCU utility
9. Verifying connections