Technical data

Table 9–1 Using Test Set-Up Mode

Step

Press This

Key... To Perform This Function... The Following Is Displayed

1. Pause Place the printer in a paused

state

Paused–

Press Resume to Continue

2. Test Set-up Select Test Set-up mode One-sided test page

3. 1 Select a two-sided test page Two-sided test page

4. 2 Select the input tray The graphic display shows the

selected tray.

5. 3 Select the output tray The graphic display shows the

selected tray.

6. 5 Print the test page One-sided test page

Two-sided test page

7. 1 Print another test page

(Repeat steps 3 through 6)

One-sided test page

Two-sided test page

8. 6 Exit Test Set-up mode Paused–

Press Resume to Continue

9. Resume Put the printer back on line Ready

9–2 Checking the Printer Paths