Installation guide

4
Installing the Paper Cassettes
The next step is to install the paper cassettes.
4.1 Assembling the Paper Cassettes
The paper cassettes come partially assembled with sizes based on the country
where the printer is shipped. You do not need to reconfigure the paper
cassettes unless your prefer to use a paper size different from those in
Table 4–1. If you need to reconfigure the paper cassettes, use the instructions
included with the cassettes.
However, you must install the metal keys included with the cassettes. These
keys help the PrintServer 32 identify the paper size in the cassette. Refer to
the instructions included with the cassettes. Also, apply the paper size labels
to the cassettes.
Table 4–1 Paper Cassette Configurations
Cassette Size U.S. Configuration International Configuration
Small Cassette Letter (11 in. x 8.5 in.) A4 (297 mm. x 210 mm.)
Large Cassette Ledger (11 in. x 17 in.) A3R (297 mm. x 420 mm.)
Note
The first number indicates the leading edge of the paper to enter the
printer. For example, the 11-inch edge of paper is the leading edge for
the 11- by 8.5-inch paper.
Refer to the instructions packaged with the cassettes to complete the assembly
by installing the metal keys and applying the paper size labels.
The Phillips screwdriver necessary to reconfigure the cassettes is in Shipaway
Kit B. The procedure is the same for both the large and small paper cassettes.
Installing the Paper Cassettes 4–1