Specifications
10.
H955)-D Mounting Panel Doors
11..
H952-B Stabilizer Feet
12. #7406782 Kick Plate
13. #7005909 Power Distribution Panel (ac ?rrd dc, mounted on upper
left side)
Approximate Size-22” wide, 39” deep (including stabilizer feet), 711/” high
Approximate
height-150
Ibs. (without computer)
e Voltage-115
V 60 Hz (for fans)
230 Y 50 Hz (for fans)
PDP-11
POWER SUPPLY SUBSYSTEM H728-This Power supply is used in
the Basic and Extension Mounting boxes and supplies power to all devices
mounted in one of these
boxes.
It is included in. basic
PDP-11
systems,
‘but must be ordered separately with a
BAllES
or BAllEC Extension Mount-
ing Box.
Approximate
Size-161/,”
wide, 8” high, 6” deep
Approximate Weight-25 Ibs.
Voltages-(specify input voltage)
IN 108V
+-lo%, 47-63
Hz
120V
*lo%. 47-63
Hz
216V
*lo%, 47-63
Hz
228V
+-lo%, 47-63
Hz
240V
*lo%, 47-63
Hz
6 amps
(H720A)
6 amps
l
(H720A)
3 amps
3 amps
gEE;
3 amps. (H7208)
OUT +5v ,*50/o
. 12 amps
-15v ‘5%
10
amps
+8RMS (unregulated)
-22v (unregulated)
1.5 amps,
1.0
amps
FREESTANDING PROGRAMMER’S TABLE (H952-HA)-This freestanding table
fits directly below the programmer’s console in the Freestanding Base
Cabinet and extends into the cabinet approximately
1”.
The surface plate is
supported by its own adjustable height legs.
Approximate Size-20” extension from cabinet,
19”
wide, 27” above floor
SYSTEM UNITS AND CABLES
The following items are available for mounting standard and special periph-
eral device logic into a PDP-11 system.
PERIPHERAL MOUNTING UNIT (DDll-A)-The
DDll
is a prewired System
Unit which allows standard small peripheral interfaces to be mounted in a
PDP-11 system. It accepts standard small peripheral interfaces (up to 4)
such as the KLll Teletype Control or the controller portion (PCll-M) of the
High Speed Reader/Punch. For mounting, it requires one-sixth (l/6) of a
BAll
Mounting Box.
BLANK SYSTEM. UNIT
(BBll)-The BBll
consists of three 288-pin con-
nector blocks connected
end-to-end.
This unit Is unwired except
for Unibus
and power connections and allows customer-built interfaces to be integrated
easily into
a PDP-11
system. For mounting it requires one-sixth (l/6) of
a
BAll
Mounting Box.
81