Specifications

6.7 Top Cover
Use the following procedure to remove the top cover (see Figure 6–7). Do
the reverse of this procedure to reinstall the top enclosure.
1. Remove the paper rack. Perform steps 1 and 3 of Section 6.4.
2. Open the cover, and disconnect the ground straps from the printer
frame.
3. Use a narrow blade screwdriver to loosen the screw that secures the
inner control panel cable access door. Carefully open the cable access
door.
4. Disconnect cable assembly CA25 (the right-most connector) at the
inner control panel by separating the connector clamps on either
side of the connector.
5. Use a medium screwdriver to remove the two screws securing the
CA25 clamp to the inner control panel. Carefully pull CA25 out
from inside the inner control panel.
6. Remove the rear access panel (see Section 6.6).
7. Use a medium screwdriver to remove the four pan head screws and
washers that hold the top enclosure in place.
8. Remove the top enclosure by lifting it up and away from the LG31
printer.
6–10 REMOVAL AND REPLACEMENT PROCEDURES