Specifications

6.5 Installing Shipping Hardware
The following procedure describes how to install the LG31 shipping
hardware.
1. Open the top cover.
2. Remove the ribbon cartridge.
3. Open the shroud cover.
4. Use an 8 mm socket wrench to install the hex head bolts, washers,
and shipping bracket that are used as horizontal restraints during
shipping (see Figure 6–3).
5. Use an 8 mm socket wrench to install the two red hex head bolts
that secure the striker bar support blocks (see Figure 6–3).
Figure 6–3: Striker Bar Shipping Hardware
RE_UK00306A_89
M5 CAP SCREWS SECURING
STRIKER BAR SUPPORT
BLOCKS DURING SHIPPING
SCREW, LOCKWASHER,
PLAIN WASHER, AND
SHIPPING BRACKET
SECURING SHUTTLE
6. Install the two red front shipping blocks.
6–6 REMOVAL AND REPLACEMENT PROCEDURES