Specifications

Table 4–4 (Cont.): Reset State Default Parameters
Selectable Parameter Reset Default Condition
Active Position Column 1, Line 1
Top Margin Line 1
Bottom Margin Line 66
Left Margin Column 1
Right Margin Column 132
Underlining Disabled
Bolding Disabled
Italics Disabled
Expansion Disabled
GL Character Set U.S. ASCII or the last NRC if selected
GR Character Set Digital Supplemental
G0 Character Set U.S. ASCII or the last NRC if selected
G1 Character Set VT100 Graphic Character Set
G2 Character Set Digital Supplemental
G3 Character Set U.S. ASCII
Autowrap Enabled
Line Feed/New Line Mode Set
Horizontal Tabs At every 8 columns (9, 17, ...137)
Unsolicited Reports Disabled
Super/Subscripts Disabled
Carriage Return New Line Mode Reset
Vertical Tabs Every Line (1, 2, ... 66)
A RESET sequence does not change the following:
• Any interface settings
• National Replacement Character (NRC) set
• Top of Form
The above parameters remain as previously selected, either through
escape sequences or through the inner control panel.
4–4 PRINTER AND HOST CONFIGURATION