Specifications

Table 3–2: Forms Setup Procedure
Action Results Display
Press (3)
ON LINE
Printer goes to OFF LINE. [ O F L]
Press (9)
FCT
Printer enters Mode Selection
state.
[.Fnc]
Press (2)
FORM FEED
Printer enters Form Setup mode. [ F S U]
At this point, choices are:
(0) TEST CLR Exits from Form Setup to OFF
LINE, and feeds to top of next
form in accordance with current
length.
[OFL]
(1) PRG Form feeds one form length. [.F S U]
(2) FORM FEED Forward line feed in accordance
with current LPI setting. If
pressed and held for more than
one second, consecutive line
feeds occur at the rate of one
each half-second.
[.F S U]
(3) ON LINE Reverse line feed in accordance
with current LPI setting. If
pressed and held down for
one second, consecutive paper
reverse line feed steps occur at
the rate of one each half-second.
[.F S U]
(8) SET TOF Advances paper 0.23 cm (1/72
inch).
[.F S U]
(9) FCT Moves paper 0.23 cm (1/72 inch)
in reverse direction.
[.F S U]
(4) LINE FEED Sets top of form. [0 0 0]
At this point the choices are:
(2) FORM FEED Forward line count display only
to required position of:
Top Margin, i.e.
Bottom Margin, i.e.
Bottom of Form, i.e.
[0 0 4]
[0 6 2]
[0 6 6]
(3)ON LINE Reverse line count display only
to required position
(5) CPI LPI Sets top margin. [0 0 4]
CONTROLS AND INDICATORS 3–7