Specifications

Table 1–1: Standard Font Dot Pattern Chart
Characters
Per Inch Font (134 ASCII Characters) Dot Pattern
10 Standard Gothic Data Processing
(default)
9H x 9V
10 NLQ 9H x 18V
12, 13.3, 15 Data Processing 7H x 9V
12, 13.3, 15 NLQ 7H x 18V
10 Italic 9H x 18V
12, 13.3, 15 Italic 7H x 18V
16.7 Gothic Data Processing Emphasized 5H x 9V
1.4.6 Ribbon Cartridge
A cartridge type ribbon with re-inker is driven by the Ribbon Drive Motor,
which is a dedicated data responsive motor. The ribbon is 59.45 m (65
yards) long by 25.4 mm (1 inch) wide, and has a rated life of 50 million
characters.
1.4.7 Paper Tractors
Two synchronized sets of six-pin tractors handle paper from 76 to 420
mm (3 to 16.54 in) wide, and up to six ply thick. Paper is stored in the
integral pedestal and fed upward through the tractors by the Line Feed
Motor Assembly. The paper passes between the print actuator modules
and the striker bar, which is situated at the upper rear of the printer.
1.4.8 Paper Out Limit Switch
A paper out sensor is used in printer operation.
1.4.9 Tabs
Horizontal and vertical tabbing in addition to perforation skip-over are
provided with the LG31 printer.
1–6 INTRODUCTION