Specifications

7.5.4 Intermodule Gap Pattern Adjustment Procedure
1. Press the FONT (7) key and observe that the printer display changes
to [.i 9 P]. The Intermodule Gap Pattern is printed. Figure 7–6A)
represents a portion of one of the two vertival bars actually printed
at the junction between the three Printer Actuator Modules. Press
the FCT (9) key to stop printing the pattern; press the FCT (9) key
again to resume printing the same pattern.
2. If the printout of the Intermodule Gap Pattern is the same as
Figure 7–6A, proceed directly to
3. If the printout is not the same as Figure 7–6 A, but looks like
Figure 7–6 B, proceed directly to the procedure in Section 5.4 and
perform the adjustment. When the print actuator modules have been
reregistered to produce the printout shown in Figure 7–6A, proceed
to
7–14 PRINT QUALITY ADJUSTMENT PROCEDURES