Specifications

6.26 Printer Fans
Use the following procedure to remove the LG31 printer fans (see
Figure 6–26). Do the reverse of this procedure to reinstall the printer
fans.
6.26.1 Front Fan
1. Open the front access panel and the shroud assembly door to access
the front fan.
2. Disconnect the two electrical spade connectors on the front fan.
3. Use a medium-size screwdriver to remove the four pan head screws
and associated hardware securing the fan.
4. Remove the front fan.
6.26.2 Rear Fan
1. Remove the top enclosure (see Section 6.6).
2. Use a medium-size screwdriver to loosen the two captive screws at
the top of the rear access panel and remove the door.
3. Remove the SHAD board (see Section 6.23).
4. Use a long shank medium-size screwdriver to remove the four pan
head screws and associated hardware securing the rear fan.
5. Remove the rear fan.
6–54 REMOVAL AND REPLACEMENT PROCEDURES