Specifications

6.21 Paper Handling Assembly
Use the following procedure to remove and replace the paper handling
assembly (refer to Figures 6–20 to 6–21).
1. Remove the top enclosure (see Section 6.7) and open the front access
panel.
2. Use a medium-size screwdriver to loosen the screws at the front of
each side panel and remove both side panels.
3. Right Side Timing Belt: Use a medium-size screwdriver to loosen the
three screws on the triangular plate on the right side of the frame,
and remove the right side timing belt (see Section 6.19).
NOTE
Disassemble only to extent necessary to replace defective com-
ponent (usually a tractor). Use care in steps 1 and 2 of the
following section to prevent inner bearings of square shaft from
falling out of side frames and becoming lost.
6–40 REMOVAL AND REPLACEMENT PROCEDURES