Specifications

6.19.2 Replacing the Paper Feed Motor
1. Mount the motor to the side frame using the four screws removed in
step 6 of the previous section.
2. Reinstall the SHAD board and enclosure removed in step 5 of the
previous section. Make sure you reconnect all SHAD board cables.
3. Top and Bottom Pulleys: Ensure that the timing mark (notch) on the
pulley is aligned with the timing mark (elongated slit) in the side
frame. Tighten the three screws removed in step 3 of the previous
section.
4. Ensure that the belt guides have slight contact with the pulley belt’s
smooth side along the entire guide surface.
5. Reconnect the motor electrical cable disconnected in step 2 of the
previous section.
REMOVAL AND REPLACEMENT PROCEDURES 6–37