Specifications

6.19.1 Removing the Paper Feed Motor
1. Remove the top enclosure (see Section 6.7).
2. Disconnect the motor electrical connectors at CA17-P2.
3. Use a wrench to loosen the three hex mounting bolts that secure the
triangular plate. This lets you release the tension on the timing belt
by pushing down on the spring in the upper left corner.
4. Remove the printer motor pulley belt by pushing down on the tension
spring to release the belt tension.
5. Disconnect the four SHAD board cables. Remove the four screws and
washers with a medium-size screwdriver to remove the SHAD board
protective enclosure from the printer frame.
6. Use a medium-size screwdriver to remove the four motor mount
screws.
7. Remove the paper feed motor.
6–36 REMOVAL AND REPLACEMENT PROCEDURES