Specifications

6.16 Line Filter Assembly
Use the following procedure to remove the line filter assembly (see
Figure 6–16). Reverse this procedure to reinstall.
DANGER STORED HIGH VOLTAGE
Wait five minutes after removing ac source before disassem-
bling. Refer to manual for service instructions.
DANGER HAUTE TENSION EMMAGASINEE
Attendre 5 minutes après avoir enlevé la source de courant
alternatif et avant de demonter la machine. Voir le manuel
pour les instructions d’entretien.
PELIGRO ALTO VOLTAJE ALMACENADO
Antes de proceder a desensamblar esto, esperar 5 minutos
despues de haber removido la fuente de C.A. para instrucciones
de servicio de mantenimiento, vease el manual.
ACHTUNG, GEFAHR HOCHSPANNUNG WIRD GESPEICHERT
Nach Abschalten der Wechselstromquelle, fünfMinuten warten,
bevor Teile demontiert werden. Bitte Bedienungsvorschrift im
Handbuch nachsehen.
CAUTION
Misplacement of any wires in the line filter assembly will cause
damage to the printer.
1. Remove the rear access panel (see Section 6.6).
2. Loosen the pan head screw at the top of the line filter box. Slide the
cover toward the rear of the printer to remove.
3. Remove the green/yellow ground wire, brown wire, and blue wire
from the slide-on terminals at the line end of the line filter assembly.
4. Remove the CA2 cable assembly (one brown wire and one blue wire).
5. Usea7mmwrench to remove the two hex nuts and lockwashers
securing the line filter assembly to the printer.
6. Remove the line filter assembly.
6–28 REMOVAL AND REPLACEMENT PROCEDURES