Specifications

6.11 Ribbon Drive Motor
Use the following procedure to remove the ribbon drive motor (see
Figure 6–11). Do the reverse of this procedure to reinstall the ribbon
drive motor.
1. Open the top cover.
2. Remove the ribbon cartridge (steps 2, 3, and 4 of Section 6.9).
3. Open the hinged cover on the shroud and ribbon drive assembly.
4. Disconnect the motor cable connector CA17-P6 (see Figure 6–10).
5. Use a 7 mm wrench to remove the three self-locking nuts and
washers.
6. Use a 7 mm wrench to remove the self-locking nut and washers
securing the ground cable to the ribbon drive motor.
7. Remove the motor by carefully lifting it up and away fromthe printer.
6–18 REMOVAL AND REPLACEMENT PROCEDURES