Specifications

6.10 Shroud and Ribbon Drive Assembly
Use the following procedure to remove the shroud and ribbon drive
assembly (see Figure 6–10). Do the reverse of this procedure to reinstall
the shroud and ribbon drive assembly.
1. Remove the top enclosure (see Section 6.7).
2. Perform steps 2, 3, and 4 of Section 6.8
3. Disconnect both connectors at the inner control panel (see Sec-
tion 6.9).
4. Disconnect cable CA25 at connector P2, located behind the inner
control panel, and to the right of the paper feed motor.
5. Open the shroud cover and disconnect the the ribbon drive motor at
cable connector CA17-P6.
6. Use a medium-size screwdriver to remove the seven pan head screws
and washers securing the shroud assembly to the printer frame.
7. At the right rear of the inner control panel, remove the two 7 mm
nuts, star washers, and the metal guard for the ribbon cable. Remove
the 20-way ribbon socket from the lower left hand corner of the inner
control panel assembly, then feed the ribbon cable under the control
panel assembly.
8. Disconnect the ground wire that connects to the top inner control
panel through the paper chute.
9. Remove the shroud and ribbon drive assembly by lifting it up and
away from the printer.
6–16 REMOVAL AND REPLACEMENT PROCEDURES