Specifications

6.9 Inner Control Panel
Use the following procedure to remove the inner control panel (see
Figure 6–9). Do the reverse of this procedure to reinstall the inner control
panel.
1. Remove the top enclosure (see Section 6.7).
2. Disconnect cable CA15 located at the lower edge of the control panel.
3. Disconnect the inner control panel ground strap connected to the
spade connector. The spade connector is located on the right side of
the control panel.
4. Use a medium screwdriver to remove the four pan head screws and
lock washers securing the inner control panel to the shroud and
ribbon drive assembly.
5. Remove the inner control panel.
6–14 REMOVAL AND REPLACEMENT PROCEDURES