Operator`s manual

4.5.5 Margin Setup
The Margin Setupprocedure shown in Table 4-8 is used to set and display
left and right margins.
Table 4–8: Margin Setup Procedure
Action Results Display
Press (3) ON LINE Printer goes OFF LINE. [ O F L]
Press (9) FCT Printer enters Mode Selection mode. [.F n c]
Press (5) CPI Printer enters Margin Setup mode. [.L r S]
At this point, the options are:
(0) TEST CLR Exits from Margin Setup to OFF LINE. [ O F L]
(1) PRG Counts column position to the left. [.1 3 2]
to
[.0 0 0]
(2) FORM FEED Counts column position to the right. [.0 0 0]
to
[.1 3 2]
(3) ON LINE Sets left margin. [.0 0 0]
Factory
Setting
(4) LINE FEED Sets right margin. [.1 3 2]
Factory
Setting
(5) CPI LPI Clears margin to default values (000
and 132 for 10 CPI). Also see Margin vs.
Character Pitch procedure below.
[.L r S]
(6) PAPER REV Displays current right margin. [.1 3 2]
(7) FONT Displays current left margin. [.0 0 0]
(8) SET TOF Displays current column position. [.0 0 0]
NOTE
The display examples given for keys (1) through (8) assume the
printer is set for 10 CPI.
4–38 SETTING COMMUNICATIONS AND PRINT PARAMETERS