Operator`s manual

Table 4–7: Forms Adjustment Procedure
Action Results Display
Press (3) ON LINE Printer goes off-line. [ O F L]
Press (9) FCT Printer enters Mode Selection mode. [.F n c]
Press (4) LINE
FEED
Printer enters Forms Adjustment mode. [.F A d]
At this point, the choices are:
(0) TEST CLR Exits from Forms Adjustment to OFF
LINE and feeds to top of next form in
accordance with current length.
[OFL]
(1) PRG Prints rotating test pattern (see NOTE). [.F A d]
(4) LINE FEED Advances paper 0.23 cm (1/72 inch). [.F A d]
(6) PAPER REV Moves paper 0.23 cm (1/72 inch) in
reverse direction.
[.FAd]
NOTE
The pattern begins and continues when key (1) PRG is pressed
and held. The pattern stops when the key (1) PRG is released.
The Forms Adjustment mode is still active after printing the
test pattern.
SETTING COMMUNICATIONS AND PRINT PARAMETERS 4–37