Operator`s manual

4.5.3 Print Adjustment
The Print Adjustment procedure shown in Table 4-6 is used to review the
print by observing several print patterns that may be selected. Except
for the test pattern, printing starts when key is momentarily pressed,
and continues printing until key (9) FCT is momentarily pressed. If key
(9) (FCT) is pressed again before another key, the previous pattern is
repeated. Further information and sample test pattern printouts are in
Chapter 7 of the LG31 Technical Manual.
The print review function permits evaluation of the print alignment for
proper character formation and graphics printing. If the adjustment is
not satisfactory, call Digital.
CAUTION
This print quality adjustment should only be performed by a
qualified technician.
Table 4–6: Print Review Procedure
Action Results Display
Press (3) ON LINE Printer goes to off-line. [ O F L]
Press (9) FCT Printer enters Function Selection mode. [.F n c]
Press (3) ON LINE Printer enters Alignment mode. Cancels
any existing special print modes.
[.A d j]
At this point, the options are:
(0) TEST CLR Exits from Adjustment to off-line and
restores previous menu configuration.
[OFL]
(1) PRG Prints short segments of the various test
patterns. Print width is governed by
the number of columns in the current
configuration. Software release number,
model number, space for printer serial
number, and date precede the test
pattern printout.
[.59]
(2) FORM FEED Executes Form Feed. [ . 5 9]
(3) ON LINE Prints amplitude pattern [.A .PL]
(4) LINE FEED Executes Line Feed. [.A .PL]
SETTING COMMUNICATIONS AND PRINT PARAMETERS 4–35