Operator`s manual

the paper. Pressing the bottom of form key (7) FONT will cause the form
parameters entered to be saved, move the paper to align the top of the
next form with the print line, and exit the Form Setup mode.
Table 4–5: Forms Setup Procedure
Action Results Display
Press (3) ON LINE Printer goes to OFF LINE. [ O F L]
Press (9) FCT Printer enters Mode Selection state. [.F n c]
Press (2) FORM
FEED
Printer enters Form Setup mode. [ F S U]
At this point, the choices are:
(0) TEST CLR Exits from Form Setup to OFF LINE,
and feeds to top of next form in
accordance with current length.
[OFL]
(1) PRG Form feeds one form length. [.F S U]
(2) FORM FEED Forward line feed in accordance with
current LPI setting. If pressed and held
for more than one second, consecutive
line feeds occur at the rate of one each
0.5 of a second.
[.F S U]
(3) ON LINE Reverse line feed in accordance with
current LPI setting. If pressed and held
down for one second, consecutive paper
reverse line feed steps occur at the rate
of one each 0.5 of a second.
[.F S U]
(4) LINE FEED Sets top of form. [0 0 1]
(5) CPI LPI Sets top margin. [0 0 4]
(6) PAPER REV Sets bottom margin. [0 6 2]
(7) FONT Sets bottom of form and returns to OFF
LINE.
[0 6 6]
(8) SET TOF Advances paper 0.23 cm (1/72 inch). [.F S U]
(9) FCT Moves paper 0.23 cm (1/72 inch) in
reverse direction.
[.F S U]
4–32 SETTING COMMUNICATIONS AND PRINT PARAMETERS