Operator`s manual

Table 4–4: Lock-Up Printer Initialization Procedure
Action Results
Turn printer power OFF. Printer disabled.
Slide the printer initialization switch to
its opposite position (Switch located at
top of inner control panel).
Turn printer power ON. Printer enabled.
When display indicates
[ . S U], press (9) FCT.
Initializes the printer to factory
settings (see Figure 4-2 printout.)
When display indicates [ . S U], slide the
printer initialization switch back to its
original position.
Completes the initialization
procedure.
NOTE
If the switch is not returned to its original position, the [ . S U]
display will reappear at next power-up or self-test procedure.
The procedure can be repeated if necessary.
4.5.2 Forms Setup
Use form setup to establish top and bottom of form and top and bottom
margin settings without causing any printing action to occur. Minimum
form length is one line. Maximum form length is 559 mm (22.0 in). The
Form Setup procedure is shown in Table 4-5.
CAUTION
Although the entire length of the form is available for printing,
top and bottom margins are recommended in order to avoid
printing on paper perforations and print wire snagging.
Prior to pressing key (4) LINE FEED, press any paper motion key to
advance paper as appropriate, and the display will not change. After
pressing key (4) LINE FEED, the display will change to a counter that
will count the line feeds forward as key (2) FORM FEED is pressed or
backwards, as key (3) ON LINE is pressed. However, the paper will not
move again until key (7) FONT LINE FEED is pressed to set bottom of
form. The top of form is actually set when key (4) LINE FEED is pressed.
At this point, the 0.23 cm (1/72 inch) paper control keys (8) SET TOF
and (9) FCT are disabled. Also, key (2) FORM FEED cannot be enabled
because it is being used to increment line feed counts without moving
SETTING COMMUNICATIONS AND PRINT PARAMETERS 4–31