Operator`s manual

4.4.2 LPI
Figure 4–15: Lines Per Inch
LPI -
0. Exit
1. 6 lpi
2. 8 lpi
3. 10 lpi
LPI - 6 lpi
Press the number ‘0’ to return to normal operation.
To continue modification select (1-8).
To select the LPI subcategory of parameters (see Figure 4–15):
1. Place the printer off-line ([OFL]isdisplayed). If the printer is
on-line ([OnL]isdisplayed), press the ON LINE key.
2. Press the PRG key ([ P r o] is displayed). The LG31 printer will print
the configuration menu.
3. Press the (2) key. The LG31 printer will list the LPI options (see
Figure 4–15).
4. Press the key with the same number as the desired LPI option ((3)
is 10 lines per inch).
5. Press the (0) key to return the LG31 printer to off-line operation ([
O F L] is displayed).
4.4.3 Forms Control
Setting the forms control (see Figure 4–16) differs from the other printing
characteristic setups in that you normally perform a sequence of settings,
and that the last setting exits back to the configuration menu. There are
two methods for setting the form dimension and position. One is to
select the function mode (see Section 4.5.2), and the other is to select
forms control from the program mode.
4–22 SETTING COMMUNICATIONS AND PRINT PARAMETERS