Operator`s manual

Table 4–2 (Cont.): Serial Interface Strapping Options

Strap

Number Action When In (In = 1; Out = 0)

A26 Enable transmission of an <ACK> on receipt of an <ETX>

A27 Reverse SCA polarity (active state LOW) if SCA is enabled

A28 Reverse DTR polarity (active state LOW) if DTR is enabled

A29 Inhibit received parity check

A30 Enable two stop bits

A31 Enable transmitter

OTHER

A32 Reverse CA polarity (active state LOW) if CA is enabled

B1 Not assigned

B2 No parity bit transmitted/received

B3 Enable auto input buffer expansion

B4 Host may not use CC to inhibit transmit

B5 Replaces underline character with <CR>

B6 Seven and eight bit data accepted

B7-B32 Not assigned

NOTE

The conﬁguration menu prints out strap status in serial inter-

face in two rows A1-A32 and B1-B32. The LED display, how-

ever, shows 1 through 64 with 33-64 being equivalent to B1-

B32.

4.4 Print Characteristics

The rest of the conﬁguration entries control the form and location of the

printed data.

4.4.1 Font

Under the font category in the program mode, there are six subcategories

(see Figure 4–8):

1. Style - the quality/density of the printed characters

2. CPI - Characters Per Inch

3. Country

4. Mode (there are no font enhancements available through the control

panel)

4–14 SETTING COMMUNICATIONS AND PRINT PARAMETERS