Operator`s manual

— Press (1) to enable the strap (an "i" in the third digit on the
display).
— Press (2) to remove the strap (an "o" in the third digit on the
display).
— Press the (0) key and the printer will return to the configuration
menu level ([ P r o] is displayed).
5. Press key (4). The LG31 printer will print the interface control
options available (see Figure 4-3).
6. To change the speed (baud rate), press (4). The printer will list
the available baud rates. The current baud rate is listed in the
configuration menu.
— Press the key which corresponds to the number of the baud rate
in the list. Having selected the baud rate, the printer returns to
the configuration menu ([ P r o] is displayed).
— Press the (0) key, and the printer will return to the configuration
menu level ([ P r o] is displayed).
7. Press key (4). The LG31 printer will print the interface control
options available (see Figure 4-4).
8. To change the parity, press the (5) key. The LG31 printer will list
the parity options (see Figure 4-5).
— Press the key which corresponds to the number of the desired
parity option. Having selected the baud rate, the printer returns
to the configuration menu ([ P r o] is displayed).
— Press the (0) key, and the printer will return to the configuration
menu level ([ P r o] is displayed).
9. Press the (0) key to exit the program mode.
There are no options available for interface type. The response of the
LG31 printer to selecting interface is shown in Figure 4–6.
SETTING COMMUNICATIONS AND PRINT PARAMETERS 4–9