Operator`s manual

Table 3–1 (Cont.): Initial Key Functions
Key
Key Function in
OFF LINE Mode
Key Function
in
ON LINE Mode
[ 05] [ 05] [n05] [n05]
[ 10] [ 10] [OcA] [Ocb]
[ 12] [ 12] [n12] [n12]
[ 13] [ 13] [n13] [n13] [06L]
[ 15] [ 15] [n15] [n15] [08L]
[16E] [16E] [16E] [16E] [10L]
(6)
PAPER
REV
Moves paper in reverse direction 0.06 mm (1/72
in) each time the key is pressed. When pressed
and held down for one second, consecutive 1/72
inch paper reverse feed steps occur at the rate of
approximately three steps per second. Inoperative
during Low Paper Print mode.
If printer strap
A26 is set,
functions same
as off-line.
Otherwise, no
operation.
(7)
FONT
Displays current font style when pressed. Holding
key down causes available font styles CPI to
be displayed on a rotating basis. The setting
displayed when the key is released becomes the
active selection. When a new font is selected, the
horizontal spacing is initially set to the default
spacing for the particular font. Displays for
standard draft and Near Letter Quality (NLQ)
are displayed only once:
No operation.
[Fon][10][12][13][15][16E]
[ c h r][ n 0 ][ n 2 ][ n 3 ][ n 5 ]
(8)
SET TOF
Set Top of Form to current position of paper.
TOF is calculated upon form length in effect. It
is assumed that the top printable dot row (±3
rows) of the form is aligned with notches in upper
tractors before key is pressed. The form is then
moved forward automatically to place the first line
at the point on the following form.
No operation.
CONTROLS AND INDICATORS 3–15