Operator`s manual

Table 3–1: Initial Key Functions
Key
Key Function in
OFF LINE Mode
Key Function
in
ON LINE Mode
(3)
ON LINE
U = ON LINE selected.
Toggles state to on-line mode.
Toggles state to
off-line mode.
(0)
TEST CLR
When pressed for more than 0.5 of a second, a
rolling test pattern is printed in the DP font at 10
CPI. Pressing (0) TEST CLR again stops the test
pattern.
No operation.
(1) PRG Prints any data in the buffer, then prints current
configuration and enters Programming state. See
Chapter 4.
No operation.
(2)
FORM
FEED
Advances paper to the next top of form setting,
once for each time key is pressed.
If printer strap
16 is set,
functions the
same as off-line.
Otherwise, no
operation.
(4)
LINE
FEED
Advances paper one line based on current LPI
setting. When pressed and held down for one
second, consecutive line feeds are performed at the
rate of approximately three steps per second.
If printer strap
16 is set,
functions the
same as off-line.
Otherwise, no
operation.
(5)
CPI LPI
Alternately displays CPI and LPI each time key
is pressed. Holding key down causes settings
available for the active font to be displayed on a
rotating basis. The setting displayed when the key
is released becomes the active selection.
The CPI/LPI key displays the current submenu -
that is, only the CPI values for the current font are
displayed.
No operation.
Displays are:
CPI(DP)CPI
(&
NLQ)
CPI
(&
OCR-
A)
CPI
(&
OCR-
B)
LPI
3–14 CONTROLS AND INDICATORS